Instruction Manual

INSTALLATION INSTRUCTIONS

Poison Spyder Customs •

JK FRONT ROCKBRAWLER BUMPER INSTALL

Page 6

corresponding holes to be drilled into the

bottomedgeoftheJeep’scrashbar.Look

through the holes to ensure that the Sub-

Frame Bracket does not interfere with any

oftheholelocations.Ifitdoes,thebracket

can be adjusted slightly in either direction

becauseyouhadleftthenutsun-tightenedin

Step16.Useahammeranda15/32”transfer

punch through each of the countersunk

holestomarkthevedrilllocationsalongthe

bottomofthecrashbar.Oncethesemarks

havebeenmade,removetheskidplate.

FIGURE 18

19.Usethedrillmotorand3/8”bittodrilltheve

holesalongthebottomofthecrashbarthat

were located and marked in the preceding

step.

FIGURE 19

De-burr the edges of the holes then use

touch-up paint or clear coat to protect the

baremetal.

20.Re-installtheskidplatewiththe3/8-16X1

SSatheadcapscrews.Thesevenscrews

which locate along the front surface of the

skid plate will thread into pre-existing weld

nuts.

FIGURE 20

For the ve screws that install along the

bottomedgeoftheskidplate,usea3/8at

washer and 3/8-16 lock nut on the inside

of the crash bar where the screw threads

protrude.Torqueall11atheadcapscrews

to30ft.-lbs.

21.Tightenthethree1/2-20locknutsatthetop

oftheSub-Frame Bracketandtorquethem

to70ft.-lbs.

22.Torque the eight (8) bumper mount lock

nuts(twoinboardandtwooutboardofeach

framerail)to70ft.-lbs.

Congratulations, you have completed the

installation of your Poison Spyder JK Front

RockBrawler Bumper!