User Manual

PoKeys user manual

www.poscope.com

6. Installation

6.1. Using USB

PoKeys57CNC is a USB 1.1/2.0 compliant device.

Step 1: Locate a free USB 2.0 port on your

computer (1) and PoKeys57CNC board (2) and

connect them with a standard USB cable.

Step 2: Connect the PoKeys57CNC board to an

appropriate power supply (3).

Step 3: Install PoKeys software

Step 4: Open PoKeys application, connect to

your PoKeys57CNC device and enable Fast USB

interface (go to Settings > Enable Fast USB

interface).

Step 5: Remove the USB cable from

PoKeys57CNC device and insert it again. The

computer will find a new device and search for

drivers. See FAQ section of the manual if driver

installation fails.

6.2. Using Ethernet - direct connection between PoKeys57CNC and computer

Network firewalls must allow all traffic on TCP/UDP port 20055 between PoKeys57CNC device and

PoKeys-related software running on a computer.

Step 1: Locate ethernet ports on your computer

(1) and PoKeys57CNC board (2) and connect

them with RJ-45 cable (standard network cable).

Step 2: Connect the PoKeys57CNC board to an

appropriate power supply (3).

Step 3: Configure your computer's network card

with a static IP address in the 192.168.x.x range

Step 4: Install PoKeys software

Step 5: Start PoKeys software, select the

PoKeys57CNC device in the list and click on

'Configure' button. Select the unique IP address

for the PoKeys57CNC device in the same range as

the computer's network card