User Manual

Wear the transmitter and attach the cycling computer to the bike mount.
1. Start heart rate measurement by pressing the OK button. The cycling computer goes into pause mode.
2. Select the bike you are going to exercise with. Bike 1 is set as a default. Select Settings > Bike > Bike 1 > OK.
Select Other if you only want to record heart rate.
Only the bikes that are switched
ON
are shown on this selection list. For further information see Bike
Settings.
The number on the bottom, right hand corner indicates the bike that is going to be used. By pressing and
holding the DOWN button, you can switch the bike quickly or switch to heart rate recording only. By pressing
and holding the UP button you can switch the exercise quickly.
3. Within 4 seconds, your heart rate appears on the display. The frame around the heart symbol indicates that
transmission is coded. The cyclist symbol on the bottom, left hand corner of the display, flashes until all the
sensors are found.
If you want to change or view different exercise settings before you start training select Settings > Exercise. Select an
exercise type or view exercise settings.
Exercise: Select Free, Basic, OwnZone or Interval, and press OK. (If you created new exercises, these will be listed, as
well.)
Select: Set a default exercise to be performed the next time you train.
View: View exercise settings.
z
Altitude: Calibrate altitude.
z
Rec.rate: Set the recording rate.
z
RR data: Switch the RR recording on or off.
z
TZ Alarm: Switch target zone alarm sounds on or off.
z
HR view: Choose to view heart rate in beats per minute (bpm), as a percentage of maximum heart rate (HR%) or
as a percentage of heart rate reserve (HRR%).
Pa
g
e 2 of 105. Trainin
g
13.11.2006file://D:\User
_
manual\CS600\ch05.html