User's Manual
Table Of Contents
- Introduction
- Quick Steps
- About the Help
- Water-Resistance
- Article Bank
- Quick Guide
- Hardware
- Software
- Introduction to Software
- Introduction to Software
- Elements, settings and functions
- How to...
- _
- How to Remove Players
- Seasons and training sessions
- How to Add Phases
- How to Add Season
- How to Add Training Periods
- How to Add Training Activities
- How to Create Training Session
- How to Delete Phases
- How to Delete Season
- How to Delete Training Period
- How to Delete Training Session
- How to Modify Phases
- How to Order Training Periods
- How to Remove Training Activities
- Training session data
- Transmitters
- PDA software
- Troubleshooting
- Important Safety Information
- Regulatory Information
- Radio Frequency Technical Specifications
- Glossary
Team2 Help EN
6
• Re-chargeable battery, Polar magnetic communication technology transmitter and built-in
Bluetooth.
• Battery lasts 30 hours in online mode and up to 250 hours in off-season mode. Re-
charge takes 12 hours.
• Transmitter memory can record 48 hours of data in online mode and up to 360 hours of
data in off-season mode.
• Bluetooth range is 100 meters (330 ft).
• Transmitter is water-resistant.
• When the transmitter is inserted into the charger, the data transfer from the transmitters
to the PC is enabled. Also transmitter settings can be changed when the transmitters are
in the charger.
• For example, the following Polar wrist units can be used with Team
2
transmitter: RS400,
CS400, S610i, S625X, S710i, S720i, S725X, S810i, AXN500 and AXN700.
• The Team
2
transmitter strap works only with Team
2
transmitters.
Bluetooth USB Adapter (USB Dongle)
The USB dongle is plugged into the PC's USB port and it can replace the base station when data
is transferred (transmitter settings, memory contents) between the transmitters and the PC. Data
can be transferred between the transmitters and the PC via the USB dongle only when the
transmitters are inserted into the charger. Online monitoring cannot be performed via USB
dongle.
FACTS:
• Built-in Bluetooth.
• Do not install the USB dongle drivers from the included CD! The USB dongle works
with the Team
2
only if the drivers are not installed. If you have installed the drivers, follow
the
instructions in the troubleshooting chapter.
Lights and Sounds
Base station and transmitters inform the user of their status with a few different lights and sounds.
Base station
Light Function
Charge indicator
Green light is on: Power cable is connected and/or the battery is full.
Red light is on: Battery is low and charging.
Red light is blinking every 5 seconds: Battery is low and not charging.
Red light blinks for 3 seconds and power switches off automatically: Battery is
empty.
Power indicator
Base station is on.
Blue 1 Base station is ready for use. Takes approx. 1 minute after switching on.