User's Manual
Table Of Contents
- Introduction
- Quick Steps
- About the Help
- Water-Resistance
- Article Bank
- Quick Guide
- Hardware
- Software
- Introduction to Software
- Introduction to Software
- Elements, settings and functions
- How to...
- _
- How to Remove Players
- Seasons and training sessions
- How to Add Phases
- How to Add Season
- How to Add Training Periods
- How to Add Training Activities
- How to Create Training Session
- How to Delete Phases
- How to Delete Season
- How to Delete Training Period
- How to Delete Training Session
- How to Modify Phases
- How to Order Training Periods
- How to Remove Training Activities
- Training session data
- Transmitters
- PDA software
- Troubleshooting
- Important Safety Information
- Regulatory Information
- Radio Frequency Technical Specifications
- Glossary
Quick Guide
7
Blue 2
PC is connected to the base station and software is running.
Blue 3
At least one transmitter is connected to the base station with Bluetooth.
Blue 4
Not in use.
NOTE:
• The Bluetooth indicator
is not a light, only a label.
Transmitter
Below is a description of lights and sounds during training.
Light/Sound Function
Green led is blinking at
HR.
Transmitter detects the HR signal and is ready for recording.
Red led is blinking at HR. Transmitter detects the HR signal and is ready for recording. Memory or battery level is
low.
Start recording sound,
one beep.
Transmitter starts recording.
Green led is blinking
every 3 seconds.
Transmitter is recording.
Stop recording sound, two
beeps.
Transmitter stops recording.
Red led is double blinking
every 5 seconds for 30
seconds.
Stop recording sound.
Recording cannot be started because the battery or memory level is low.
Red led is double-blinking
every 5 seconds for 10
minutes.
Stop recording sound.
Recording has been stopped because the transmitter memory is full or the battery is
empty.
Below is a description of lights and sounds during charging.
Light/Sound Function
Red led is on for 5 Transmitter is properly placed into the charger.