User's Manual
Table Of Contents
- Introduction
- Quick Steps
- About the Help
- Water-Resistance
- Article Bank
- Quick Guide
- Hardware
- Software
- Introduction to Software
- Introduction to Software
- Elements, settings and functions
- How to...
- _
- How to Remove Players
- Seasons and training sessions
- How to Add Phases
- How to Add Season
- How to Add Training Periods
- How to Add Training Activities
- How to Create Training Session
- How to Delete Phases
- How to Delete Season
- How to Delete Training Period
- How to Delete Training Session
- How to Modify Phases
- How to Order Training Periods
- How to Remove Training Activities
- Training session data
- Transmitters
- PDA software
- Troubleshooting
- Important Safety Information
- Regulatory Information
- Radio Frequency Technical Specifications
- Glossary
13
Hardware
Hardware
Polar Team
2
includes the following hardware:
•
Base station
•
Charger
•
10 transmitters and straps
•
USB dongle
Extra transmitters and Team
2
transmitter straps can be purchased separately. There is also a
charger included in the transmitter kit.
Hardware
Polar Team
2
includes the following hardware:
•
Base station
•
Charger
•
10 transmitters and straps
•
USB dongle
Extra transmitters and Team
2
transmitter straps can be purchased separately. There is also a
charger included in the transmitter kit.
Base Station
The base station is the device that connects the transmitters with your PC or PDA. To connect
the base station to the PC, follow these instructions:
1. Turn on your PC and open Team
2
software.
2. Plug the power cable into the base station. NOTE that using power cable is only allowed
indoors. During outdoor use, use the battery as power source.
3. Connect the base station to the PC with the network cable.
4. Switch on the base station. Wait until (1) and (2) are lit (approx. 1. min).
When the lights (1) and (2) are lit, the base station is ready to communicate with the PC.