User's Manual
Table Of Contents
- Introduction
- Quick Steps
- About the Help
- Water-Resistance
- Article Bank
- Quick Guide
- Hardware
- Software
- Introduction to Software
- Introduction to Software
- Elements, settings and functions
- How to...
- _
- How to Remove Players
- Seasons and training sessions
- How to Add Phases
- How to Add Season
- How to Add Training Periods
- How to Add Training Activities
- How to Create Training Session
- How to Delete Phases
- How to Delete Season
- How to Delete Training Period
- How to Delete Training Session
- How to Modify Phases
- How to Order Training Periods
- How to Remove Training Activities
- Training session data
- Transmitters
- PDA software
- Troubleshooting
- Important Safety Information
- Regulatory Information
- Radio Frequency Technical Specifications
- Glossary
Team2 Help EN
14
FACTS:
• The base station is water-resistant so it can be used in the rain as long as the plug is in
place. Always use wireless connection and battery power in the rain!
• Allows you to monitor up to 28 players in real time at the same time.
• Built-in Wi-Fi (IEEE802.11b) so that wireless connection can be used between the
PC/PDA and the base station.
• Built-in Bluetooth (100 m (330 ft) range).
• RJ45 connector for Ethernet connection.
• Re-chargeable batteries with up to 12 hours stand alone use. Charging time 4 hours.
• AC adapter included. There are four different plugs for the AC adapter included. Choose
the correct plug (according to the country) and place it into the adapter.
• Operating temperature -20°C - +60°C (-4°F - +140°F).
• The stand must be used when base station is placed on moist ground, e.g., on a wet
lawn.
• When the base station is placed on the wall, the plug must be towards the ground,
especially outdoors.
• During charging the legs of the base station must be used because the bottom heats up.
• The bottom of the base station heats up to 60°C (140°F).
• It is recommended that the base station is placed 2 meters (6.5 ft) above the ground to
optimize the signal.
• Check the range of the signal if the base station is surrounded by metal.
• Wall mount and legs included.
• The sockets that are provided in the wall mounting kit are meant for concrete surfaces.
Charger