User's Manual

Hardware
15
Charger is used to re-charge the batteries of the transmitters. The charger can be used only
indoors. Data transfer (transmitter settings, memory contents) between the transmitters and the
PC is enabled only when the transmitters are inserted into the charger.
To transmit data between transmitters and PC, follow these instructions:
1. Turn on your PC and open Team
2
software.
2. Connect the base station to PC according to the
instructions.
3. Plug the power cable into the charger.
4. Insert transmitters into the charger. Wait until (3) is lit in the base station.
If the transmitter is inserted correctly into the charger, you hear one short sound and red led is on
for 5 seconds. Software's
toolbar shows in the upper right corner how many transmitters are
connected to the base station/USB dongle.
FACTS:
• Up to 10 transmitters can be inserted into the charger at a time.
• The transmitters are inserted into the charger in such a way that the led light is left on the
outside. The led is located next to the Polar Team
2
logo's letter R.
• Not water-resistant, for indoor use only.
• AC adapter included. There are four different plugs for the AC adapter included. Choose
the correct plug (according to the country) and place it into the adapter.
• Wall mount included.
Transmitters and Straps
Transmitter records heart rate data and transmits it to the PC using Bluetooth. During training the
heart rate data can also be monitored with a Polar wrist unit. During the training transmitter is
attached to the Team
2
transmitter strap and the strap is secured around player's chest. NOTE:
Two electrode areas on the back of Team
2
transmitter strap must be made wet under running
water before use.