User's Manual
Table Of Contents
- Introduction
- Quick Steps
- About the Help
- Water-Resistance
- Article Bank
- Quick Guide
- Hardware
- Software
- Introduction to Software
- Introduction to Software
- Elements, settings and functions
- How to...
- _
- How to Remove Players
- Seasons and training sessions
- How to Add Phases
- How to Add Season
- How to Add Training Periods
- How to Add Training Activities
- How to Create Training Session
- How to Delete Phases
- How to Delete Season
- How to Delete Training Period
- How to Delete Training Session
- How to Modify Phases
- How to Order Training Periods
- How to Remove Training Activities
- Training session data
- Transmitters
- PDA software
- Troubleshooting
- Important Safety Information
- Regulatory Information
- Radio Frequency Technical Specifications
- Glossary
Team2 Help EN
18
How to Insert Transmitters into Charger
Transmitters are inserted into charger for 3 reasons:
• To recharge the batteries.
• To transfer training data from the transmitters to PC.
• To change the transmitter settings (online/off-season).
Inserting the transmitters into the charger:
• The transmitters are inserted into the charger so that the P of the Polar logo is not visible.
The led is located next to the R of the Polar logo. The power cable of the charger must be
plugged in.
• When the transmitter is inserted correctly into the charger the red led is on for 5 seconds.
At the same time you can here a short sound.
How to Introduce USB Dongle
If the USB dongle has not been plugged in during Wizard, it cannot be used as a secondary
option for the base station, because the USB dongle does not recognize the transmitters. Before
the USB dongle can be used for transferring data from the transmitters' memory to the PC, it has
to be introduced to the system. It can be done according to the following steps:
1. Open the Team
2
PC software.
2. Plug in the USB dongle into the free USB port.
3. Insert all the transmitters into the charger and plug in the power cable.
4. The system will automatically detect the USB dongle and introduce the inserted
transmitters to the dongle. The USB dongle will appear on the USB dongle list in the
software preferences (Tools > Preferences > Base station/USB dongle tab).
5. Repeat steps 3 and 4 if you have more than 10 transmitters.
NOTE:
• Do not install the USB dongle drivers from the included CD! The USB dongle works
with the Team
2
only if the drivers are not installed. If you have installed the drivers, follow
the
instructions in the troubleshooting chapter.
How to Setup Wireless Connection
The base station can be connected to the PC with either wired (Ethernet) or wireless (Wi-Fi)
connection. Instructions for creating a wired connection between the base station and PC can be
found
here. Wired connection is necessary when Team
2
is used for the first time.
Wireless connection requires that there is a Wi-Fi adapter installed into the computer.
Network key
Wireless connection requires a wireless network key so that it's possible to establish secured
wireless connection. Secured connection prevents an outsider from connecting to the base
station's wireless network. Wireless network key is selected in wizard during the first run of Team
2