User's Manual

Software
29
Add New Transmitters
When the original 10 transmitters are not enough or some of the original transmitters have to be
re-added, the Add new transmitter function becomes handy. New transmitters can be added by
using the base station or the USB dongle.
Do not attach number labels to empty transmitters beforehand!
To add transmitters, follow these steps:
1. Open the Team
2
software.
2. Connect the base station to the PC.
3. Remove transmitters from the charger.
4. Click Tools > Add New Transmitter. A popup window appears.
5. As the instructions on the display tell, insert only new transmitters into the charger and
plug the power cable into the charger.
6. Make sure that you have the base station connected to the PC (lights 1 and 2 are on).
7. Click the Search new transmitter(s) button. Wait until the search is done.
8. After the search is done, the software tells you how many transmitters were found. If you
have more transmitters in the charger than were found, make sure the transmitters are
inserted
correctly and click Search new transmitter(s) again.
9. After all the transmitters have been found, select the first transmitter on the transmitter list
by clicking it.
10. Next, click the Activate connection button. The red box in front of the chosen transmitter
turns to green and starts blinking. At the same time, the green light is lit on one of the
transmitters in the charger. NOTE: It may take couple of seconds for the green light to
light up!
11. To finalize the connection, remove the transmitter that has a green light on it, from the
charger.
12. Mark the transmitter with number label that is in accordance with transmitter's number.
13. Repeat steps 9 to 12 until all the transmitters are activated and labeled.
14. End by clicking the Finish button.
Software Preferences
Polar Team
2
Preferences can be found from main menu: Tools > Preferences. Preferences can
be changed without selecting a team. There are 3 tabs in Polar Team
2
Preferences.
Settings are taken into use by clicking the Save button, the window is closed by clicking the
Close button. NOTE: Close only closes the window; new settings are not taken into use if Save
is not clicked.
General
Language and training session transfer settings can be found from the General tab.
• To change software's language select correct language from the drop-down list. There
are 7 options: English, German, French, Dutch, Spanish, Italian and Portuguese.
• To take automatic error correction into use check the box in front of Heart rate curve's
automatic error correction. This feature corrects the heart rate data during it's being
transferred from the transmitter's memory or from a wrist unit's memory.
• To take automatic merging of training sessions into use check the box in front of Merge
training sessions if... Select also the time limit (in seconds) for merging.