User's Manual

Team2 Help EN
44
• A phase is an individual section of training session, for example, certain exercise that
repeats in the team's training.
• Phases can be used only with the training activity for which they are specified. For
example, football can have 3 vs. 3 and warm up phases.
• The number of phases is not limited per training activity.
• Phases must be created beforehand in Team Properties (Options > Team Properties).
• Session and phases form a fixed "block" which has to be used as it is. When a session
that has phases is selected, phases must be used. In that case the duration of phases
determine the duration of that specific session. Although session with phases is fixed, the
duration of phases can be changed training session by training session.
• The same phase can be part of several sessions. For example, 3 vs. 3 can be a part of
60 min Football session and 45 min Football session.
• Sessions are fixed to specified sessions in Session Management.
Creating a Phase
1. Open Team Properties (Options > Team Properties).
2. Open the Training Activities tab.
3. Select a training activity from the list on the left.
4. Click the Add button below the Training activity phases list.
5. Type in name for the phase.
6. Repeat steps 3 to 5 if necessary.
7. Close the window by clicking OK.
Using of Phases
Before phases can be taken into use, training session must be created by clicking Add in the
Training Sessions window.
Phases are taken into use in Session Management, which can be accessed by clicking the
icon in the Training Sessions window. The training session from the Training sessions list must
be selected by clicking it before the icon is enabled.
After the session with phases is created (in the following two ways), the session is selected
normally from the drop-down list next to the new session icon
in Training Sessions window.
Phases to previously created session:
1. Open Session Management.
2. Select the session from the list on the left by clicking on it.
3. Check the Training with phases box.
4. Click the Add button in the Phases section.
5. Select a phase from the drop-down list. NOTE: Phases are created beforehand in Team
Properties.
6. Repeat steps 4 and 5 to add more phases to the session.
7. Close the window by clicking OK. Cancel by clicking Cancel.
Phases to new session:
1. Open Session Management.
2. Click the Add button below the session list.
3. Type in the session name and select a training activity from the Training activity drop-
down list.