User's Manual
Table Of Contents
- Introduction
- Quick Steps
- About the Help
- Water-Resistance
- Article Bank
- Quick Guide
- Hardware
- Software
- Introduction to Software
- Introduction to Software
- Elements, settings and functions
- How to...
- _
- How to Remove Players
- Seasons and training sessions
- How to Add Phases
- How to Add Season
- How to Add Training Periods
- How to Add Training Activities
- How to Create Training Session
- How to Delete Phases
- How to Delete Season
- How to Delete Training Period
- How to Delete Training Session
- How to Modify Phases
- How to Order Training Periods
- How to Remove Training Activities
- Training session data
- Transmitters
- PDA software
- Troubleshooting
- Important Safety Information
- Regulatory Information
- Radio Frequency Technical Specifications
- Glossary
Team2 Help EN
86
• Make sure you have enabled PDA's Wi-Fi adapter.
• Make sure you have the correct settings in the Wi-Fi adapter settings. See
How to
establish wireless connection for instructions how to check the settings.
• Make sure you have the correct wireless network key. If you have forgotten your wireless
network key, change it according to the
instructions.
• If all the settings are set correctly, switch off the base station and close the PDA software
(Menu > Quit). Then switch on the base station and open the PDA software again.
NOTE: If the wireless connection works between the PC and the base station but not between
the PDA and the base station, the problem is most likely in your PDA settings.
Online Training
Below are a few common problems with online training. Go through the list to get firsthand help.
Problem Cause Solution
Transmitter/Player's information
disappears from the list.
1) Transmitter's memory is full.
2) Transmitter's battery is empty.
3) Strap's electrode areas are dry or
strap is secured incorrectly.
4) Connection between the PC/PDA
and the base station is momentarily
disconnected.
5) Base station's battery is empty.
6) The transmitter is out of the base
station's range.
1) Transfer training data from
transmitter to the PC.
2) Recharge transmitter's battery.
3) Wet the electrode areas of the
strap under running water. Make
sure that the strap is secured
correctly and the wet electrode
areas are firmly against player's
skin.
4) Wait for a moment. If connection
is not restored, switch the base
station off and on again. Also re-
open the software and establish
connection between PC and base
station normally.
5) Plug the power cable into the
base station.
6) Wait until the player is again in
the base station's range. The
transmitter has a buffer memory so
short gaps can be corrected during
the online training.
Cases 4 and 6: If there is a long gap
(several minutes) in data recording
during the online training, the data
can be completed by transferring
the data from the transmitter's
memory after the online training
according to the
instructions.
Transmitter/Player is not shown
during online training.
1) Transmitter's battery is empty.
2) Strap's electrode areas are dry or
strap is secured incorrectly.
3) Connection between the PC/PDA
and the base station is momentarily
1) Recharge transmitter's battery.
2) Wet the electrode areas of the
strap under running water. Make
sure that the strap is secured
correctly and the wet electrode
areas are firmly against player's
skin.