User's Manual

Troubleshooting
87
disconnected.
4) Base station's battery is empty.
5) There is not a player assigned to
the transmitter.
6) Transmitter is in off-season
mode.
7) Transmitter is in non-secured
mode.
3) Wait for a moment. If connection
is not restored, switch the base
station off and on again. Also re-
open the software and establish
connection between PC and base
station normally.
4) Plug the power cable into the
base station.
5) Assign a player to the transmitter
in Team Properties (Options >
Team Properties > Players tab).
6) Change the transmitter's mode to
online in preferences according to
the instructions in
software
preferences.
7) Change the transmitter's mode to
secured by inserting the transmitter
to the charger (power cable must be
plugged in), removing the
transmitter from charger and
inserting it back after a minimum of
3 seconds. Only one sound should
be heard.
Sport Zones
Below are a few common problems with sport zones and sport zone settings. Go through the list
to get firsthand help.
Problem Cause Solution
New sport zone cannot be added. Low value of lowest existing sport
zone is 0.
Modify the Low value of the lowest
existing sport zone so that it's larger
than 0.
There is not Remove button in the
rear of the sport zone.
Sport zone in question is the original
sport zone.
Original sport zones cannot be
removed.
Transmitters
Below are a few common problems with transmitters. Go through the list to get firsthand help.
Problem Cause Solution
When inserted into charger, three
short sounds are heard instead of
one.
Training data cannot be transferred
from the transmitters to PC.
Transmitter is in not-secured mode,
because it is removed from and
inserted back into the charger within
3 seconds.
Change the transmitter's mode to
secured by removing the transmitter
from charger and inserting it back
after a minimum of 3 seconds. Only
one sound should be heard.
When inserted into charger, there is
no sound or light.
1) Power cable is not plugged into
the charger.
2) Transmitter is inserted into
charger incorrectly.
1) Plug the power cable into charger
and into the wall outlet.
2) Insert transmitter into the charger
so that the P of Polar logo is not
visible. The led is located next to
the R of Polar logo.