User manual

Remember to detach the connector from the strap to cut the connection between the heart rate sensor

and Polar Loop 2. Leaving the connector attached consumes the battery of your Polar Loop 2.

After removing the heart rate sensor, wait two minutes before trying to use it with any other device or soft-

ware.

After training, your data is synced automatically to Polar Flow mobile app, if you've taken the app into use and

it is running on your mobile device.

Syncing

Keep your activity and training data up-to-date between your Polar Loop 2, the Polar Flow web service and the

Polar Flow mobile app wherever you are. You can sync your data wirelessly to the mobile app and via mobile

app or USB cable to Polar Flow web service.

To keep your data safe, sync your Polar Loop 2 before it's memory comes full, of which your Polar Loop 2 will

notify you with MEM. FULL message. See more information in Display messages.

Sync with Flow App

The data is synced from your Polar Loop 2 to Polar Flow app via Bluetooth and from Polar Flow app to Polar

Flow web service via an internet connection. Your Polar Loop 2 syncs the data automatically to the Polar Flow

app for iOS, when you reach your daily activity goal, when you get an inactivity alert and after you've stopped

training with a heart rate sensor. You can also sync your data any time by tapping the touch button of your

Polar Loop 2. Pressing the button will start the synchronization if there hasn't been one in the last 15 minutes.

Sync to Polar Flow app works, if the Flow app is running on your mobile device, at least in the background,

your phone is within the range of 10 m / 33 ft from your Polar Loop 2, and the Bluetooth is turned on in your

mobile device.

To sync data from Polar Loop 2 to Polar Flow app for Android, start the app and tap the touch button on your

Polar Loop 2. For more detailed instructions, visit polar.com/support.

For support and more information about using Polar Flow app, go to polar.com/support/Flow_app

Sync With Flow Web Service Via FlowSync

To sync data with the Polar Flow web service you need FlowSync software. You've already installed the soft-

ware, when you set up your Polar Loop 2.

1. Plug your Polar Loop 2 into your computer with the USB cable. Make sure FlowSync software is run-

ning on your computer.

2. The FlowSync window opens on your computer, and the syncing starts.

3. Completed is displayed when you're done.