Operation Manual

Polar BodyAge System SW Help
• To replace the fuses, make sure the power
is unplugged and completely disconnected
from the power.
• Next, using a small flathead screwdriver,
pry the cover open on the far right side.
• Carefully pry the fuses out and insert the
new fuses.
• Close the cover, insert the power cord and
turn the power switch on “|”.
Platform/Scale
• Screw in the eyebolt on
the scale strap assembly
into the top of the
platform. Make sure it is
tightened all the way.
• Attach the “C” connector
on the strength strap
assembly to the strength
handle. Make sure it is
tightened all the way.
• Check the strap for any
wear or defects before
each use, as this can
cause injury to the client
being tested on the
biceps strength test.
Ergofit Ergometer
The ErgoFit bike needs to be connected to the Polar BodyAge® System with a null modem cable.
This cable plugs into the back bottom of the ErgoFit ergometer. Plug the other end of the serial
cable into an available serial port in the back of the CPU.
Note: The serial cable is a 9-pin null-modem Cable. You must use a null-modem cable or a null-
model adaptor for the Ergofit Ergometer to function properly with the Polar BodyAge® System.
103