User's Manual

• A cardiac event may have altered your ECG waveform. In this case, consult your physician.
…Check WearLink! is displayed and your cycling computer cannot find your heart rate signal?
• Make sure the cycling computer is no further than 40 m/131 ft from the heart rate sensor.
• Make sure the heart rate sensor strap has not loosened during exercise.
• Make sure the textile electrodes in sports apparel fit snugly.
• Make sure that the electrodes of the heart rate sensor / sports apparel are moistened.
• Make sure the heart rate sensor / electrodes in the sports apparel are clean and undamaged.
• If the heart rate measurement does not work with the sports apparel, try using a Soft strap. If your heart
rate is detected with the strap, the problem is most probably in the apparel. Please contact the apparel
retailer / manufacturer.
• If you have done all of the above-mentioned actions, and the message still appears and heart rate
measurement does not work, the battery of your heart rate sensor may be empty. For further information,
see Care and Maintenance (page 61).
Your cycling computer refers to the heart rate sensor as WearLink.
…New WearLink found. Teach new WearLink? is displayed?
If you have purchased a new heart rate sensor as an accessory, it will have to be introduced to the cycling
computer. For further information, see Using a New Heart Rate Sensor (page 54).
If the heart rate sensor you are using is included in the product set, and the text appears on the display,
the cycling computer may be detecting the signal of another heart rate sensor. In that case, make sure you
are wearing your own heart rate sensor, that the electrodes are moistened, and that the heart rate sensor
strap has not loosened. If the message still appears, the battery of your heart rate sensor is empty. For
further information, see Care and Maintenance (page 61).
...Check Speed! is displayed?
For further information, consult Speed Sensor W.I.N.D. user manual.
…Check Power! is displayed?*
Check that the power sensor function is activated in the cycling computer. If so, the cyclist symbol should
be displayed on the computer. Make sure your power sensor is positioned correctly. The battery of your
power sensor may be empty. For further information, see power sensor user manual.
...Teach new sensor? is displayed?
If you have purchased a new Polar H3 heart rate sensor, Polar Cadence Sensor W.I.N.D.* or Polar LOOK
Kéo Power system* as an accessory, it will have to be introduced to the cycling computer. For further
information, see Using a New Accessory (page 55).
...the altitude keeps changing even if I am not moving?
The cycling computer converts measured air pressure into an altitude reading. This is why changes in the
weather may cause changes in altitude readings.
…the altitude readings are inaccurate?
Your altimeter may show faulty altitude if it is exposed to external interference like strong wind or air
conditioning. In this case, try to calibrate the altimeter. If the readings are constantly inaccurate, dirt may
be blocking the air pressure channels. In this case, send the cycling computer to a Polar Service Center.
...Memory low is displayed?
Memory low is displayed when there is approximately one hour of memory space left. Once the memory
has been depleted Memory full is displayed. To free memory space, transfer exercise data to Polar
ProTrainer 5 software, and delete from the cycling computer memory.
ENGLISH
Customer Service Information 67