Operation Manual

GB 12
Red indication
lights up
Indication on
display
(if fitted on your
machine)
Description
Causes
Solutions
“Service”
from “F02” to “F35”
(except “F24”)
“Electrical module fault”
Select and start the “Drain” programme or push the
“Reset” button for at least 3 seconds.
from “F40” to “F43” “Electrical module fault”
Make sure that the water tap is open. If yes:
• Switch the washing machine off or turn the
programme selector to the “Off/O” position; then
switch it on again or turn the programme selector
to a wash programme. If there is still a failure:
• Select and start the “Drain” programme or push
the “Reset” button for at least 3 seconds.
“F24” “Water level too high” (after programme
cancellation or false operating). Switch off the
appliance (by pressing the “On/Off” button or by
turning the programme selector to the “Off/O”
position - depending on the model) and then switch
it on again, select “Drain” and start within 15 sec.
“F02” or “FA” “Waterstop fault”
Switch off the appliance the appliance (by pressing
the “On/Off” button or by turning the programme
selector to the “Off/O” position - depending on the
model), pull out mains plug and turn the water tap
off. Tilt the appliance forward carefully to allow
collected water to flow out from the bottom. Then:
• Plug in the appliance again.
• Turn the water tap on (if water immediately flows
into the appliance without the appliance being
started, there is a failure; turn off the tap and notify
the After-Sales Service).
• Select and start the desired programme again.
“Fod” “Overfoaming”
Too much foam interrupted the wash programme.
• Select and start the “Rinse & Spin” programme.
• Afterwards select and start the desired
programme again, using less detergent.
If any of the faults described above persist,
unplug the appliance, turn off the water tap
and contact our After-Sales Service (see next
chapter).
IFU Delta-Domino_LR-HR-STEAM-GB NEW.fm Page 12 Monday, September 15, 2008 3:59 PM
Black process 45.0° 100.0 LPI