Owner's Operation and Maintenance Manual

A-- 40
MAINTENANCE
Brake Adjustment
4. Install brake
band. Route
cable through
cable housing.
Install spring
on cable and
thread cable
through set
screw barrel.
Hold opposite
slotted side
with flat tool
such as a
feeler gauge.
Insert 1/8″
allen wrench.
Pull cable
through barrel and tighten. The brake band is adjusted correctly when there is
1/8″-3/8″ (6-10mm) brake lever free play, and clearance between brake lever
and block with lever fully depressed is no more than 3/4″ (1.9cm). See page
2.4 for brake cable adjustment procedure. Torque band bolt 6 ft. lbs. (83
kg2-m)
Torque
Insert cable through housing