Owner's Operation and Maintenance Manual

A-- 47
MAINTENANCE
Track Tension (Cont.)
If the track needs adjustment:
5. Loosen rear idler shaft bolt (D).
6. Tighten or loosen the track adjusting screws (B) as necessary to provideequal
adjustment on both s ides of the track.
7. Repeat measurement on the other side of the track. NOTE: Check more
frequently when machine is new.
8. Start machine and slowly rotate the track at least five revolutions, let the track
stop rotating by itself (do not apply brakes).
9. Check track alignment (side to side) by comparing the distance from the guide
clip to Hi-fax on both sides. Readjust until centered.
10. Tighten Idler Shaft Bolt (D)
11. Readjust the toe block to proper spacing and tighten.