Industries Automobile User Manual

MAINTENANCE AND LUBRICATION

Lights

Headlight Housing Replacement

1. Remove the two screws on the lower front corners of the headlight

pod.

2. Using a small flat-blade screwdriver, push in on the lock tab

through the two small openings at the front of the headlight pod.

3. Lift the pod slightly while depressing the tabs.

4. Remove the screw in the back of the

headlight pod.

5. Lift the pod cover. Disconnect the

speedometer harnesses from the

speedomet er. Unplug the indicator

light harness and remove the pod cover.

6. Unplug the headlamp from the wiring

harness.

7. Remove the o-ring (1) from t he

headlight pivot pins.

8. Pull the headlight housing up t o

release from the locking tabs.

9. Lift the adjusting knob up to remove

from the locking tabs.

10. Carefully pull the assembly up and

out of pod.

11. Reverse the steps to install the new housing and reassemble the

pod.

NOTE: The distance from the headlamp parting line to the end of the

adjustment knob stop is 5 1/8″ (13 cm). See illustration.

12. Adjust the headlight aim by turning the adjusting knob.

51/8″

(13 cm)