Industries Automobile User Manual

MAINTENANCE AND LUBRICATION

Adjustments

Wheel Installation

1. Place the transmission in gear

and lock the parking brake.

2. Apply a small amount of

red Loctitet (provided with

your ATV) to the studs if

the nuts are regular nuts.

Do not apply Loctitet if

the nuts have an attached

washer.

3. Place the wheel on the

wheel hub with the valve stem

toward the outside and rotation

arrows on the tire pointing toward

forward rotation.

4. Install the wheel nuts and finger tighten.

5. Lower the vehicle to the ground.

6. Torque the wheel nuts according to the wheel nut torque

specifications chart.

NOTE: All nuts that have a cotter pin installed must be serviced by an

authorized Polaris dealer.

Wheel Nut Torque Specifications

Check the wheel nut torques occasionally and when they’ve been

loosened for maintenance service.

Bolt Size Specification

Front 3/8″ 30 ft. lbs. (41 Nm)

Rear 3/8″ 30 ft. lbs. (41 Nm)

Front Wheel Hub Tightening

Front wheel bearing tightness and spindle nut retention are critical

component operations. All service must be performed by your

authorized Polaris dealer.