Instructions / Assembly

ASSEMBLY

Front Brake

Determine which type of brake your bike is equipped with and refer to

the appropriate assembly instructions. For more information on brake

adjustment and maintenance.

Cantilever Brakes – Link Wire

If fitted with cantilever type brakes, insert the brake cable into the link wire

lead, and notch the cable end into the slot of the left brake cable under the

tabbed washer. Squeeze both brake arms together so the brake shoes hit

the rim, pull all slack out of the brake cable, and tighten the anchor bolt.

With the cable fitted, the straddle holder should sit 10 – 20mm above the

reflector bracket. Adjust the brake shoes using a 10mm wrench so that

they are parallel with the rim and are positioned 1-2mm away from the

rim. Several adjustments may be necessary to achieve the correct brake

position.

curved part of the lever faces the bicycle.

5. The wheel is tightly secured when the serrated surfaces of the quick

release clamping parts actually begin to cut into the bicycle frame/fork

surfaces.

6. Note that the same procedure applies when operating a quick release

seat post binder mechanism.

Warning – Correct adjustment of the quick release is

vitally important to avoid an accident caused by loose

wheel.

1. Install the cable into

the link wire.

2. Set the cable into

the straddle holder.

Cantilever

Brakes

Cable

End