Instructions / Assembly

39
ASSEMBLY
Front Derailleur
Shift both shifters to the smallest number indicated and place the chain
on the corresponding cog and chainwheel. Disconnect the front derailleur
cable from the cable anchor bolt. Check the position of the front derailleur; it
should be parallel with the outer chainwheel and clear the largest chainwheel
by 3-5mm when fully engaged.
With the chain on the smallest chainwheel in front and the largest cog
in back, adjust the Low limit screw so the chain is centered in the front
derailleur cage. Reconnect the cable, pull any slack out, and tighten the
anchor bolt securely. Shift the front shifter to the largest chainwheel. If the
chain does not go onto the largest chainwheel, turn the high limit screw in
1/4 turn increments counter-clockwise until the chain engages the largest
chainwheel. If the chain falls off the largest chainwheel, and into the pedals,
you will need to turn the High limit screw in 1/4 turn increments clockwise
until the chain no longer falls off. Shift through every gear, using the barrel
adjusters to fine-tune each transition. The barrel adjuster for the front
derailleur is located on the front shifter where the cable comes out of the
shifter. Clockwise will loosen the cable tension and direct the chain closer to
the frame while counter-clockwise will tighten the cable tension and direct
the chain away from the frame.
Do not ride a bicycle that not shifting properly.
Overlooking proper adjustments may cause irreparable
damage to the bicycle and/or bodily injury.
Low Adjusting Screw
Cable Anchor Bolt
Outer Chainguide
Inner Chainguard
High Adjusting
Screw
Chainguide
clearance of
1-3mm