Owner's Manual

IfthePolariscleanerregularlydisplaysthefollowing
actions,adjustmentsmaybenecessarytorestore
performance.Refertoexplodedpartsdiagramforpart
references.
Action: Polarisdoesnotcleanthe 
entirepoolorrunsslowly.
Solution: 1. Verifythatthepressurereliefvalveis
releasingwater.Ifitisnot,cleanor
backwashthepoolfilter.
 2. Checkthefilterscreeninthequick
disconnectandcleanifnecessary.
 3. Verifythatthefloathoseistheproper
length.
 4. Removethesurfacemoduletop.
WiththePolarisoperating,verifythat
therandomizertubeismovingback
andforth.
If it is notmoving:Turnoff
pump,disconnecthoses,lookinto
themechanismandlocatethefilter
connectorinsidetherandomizer
tube.Ifitiscoveredwithdebris
oralgae,removetheconnector
chamber,cylinder,andpiston.Pull
outtherandomizertubeandclean
thefilterconnector.Iftheconnector
isclean,replacethepiston.
If it is moving:Watchthe
randomizerballinthemechanism.
Ifitdoesnotmovewithin2minutes,
replacetherandomizertubeand
piston.
 5. Verifythatthewaterpressureis
between5and10psi.Apressure
tester(part#6-113-00)isavailable
throughyourparticipatingPolaris
dealer.
Action: Surfacemoduledivesunderthe
waterorleanstooneside.
Solution: 1. Straightentwistedhoses.
 2. Liftsurfacemoduleoutofthewater,
emptyitandthenshakeit.Ifwater
isstillheardinside,removethetop,
pulloutthedrainplugassemblyand
drainthemodule.
 3. Adjustthepressurereliefvalveuntil
thesurfacemodulelevelsoff.
 4. Verifythatthewaterpressureis
between5and10psi.
Apressuretester(part
#6-113-00)isavailablefroman
authorizedPolarisdealer.
Action: Thefloathoseremainscoiled.
Solution: 1. See“Polarisdoesnotcleanentire
pool.”
 2. Laythefloathoseoutstraightinthe
suntoremovethecoils.
Action: Surfacemodulemovestoofast.
Solution: 1. Adjustthepressurereliefvalveuntil
thesurfacemoduleslowsdown.
2. 165/SuperTurtleonly:Remove
oneoftheeyeballregulatorsand
readjustthepressurereliefvalveif
necessary.
 3. Verifythatthewaterpressureis
between5and10psi.
Action: Bagdoesnotstayonthe
pool floor.
Solution: 1. Verifythatthebaghasbeeninstalled
correctly.
 2. Checkforairbubblesaroundthejet
bodyassembly.Thismayindicate
airintheplumbinglines.
 3. See“Surfacemodulemovestoo
fast.”
www.polarispool.com
English
Troubleshooting