Outdoor Decoration LED projector “Snowflakes” Item no.
Intended use Use this product to decorate interior and exterior spaces (IP44). For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product for purposes other than those described above, the product may be damaged. In addition, improper use can cause hazards such as short-circuiting, fire, electric shock etc. Read the instructions carefully and keep them. Make this product available to third parties only together with its operating instructions.
a) Persons / Product • The device is not a toy. Keep it out of the reach of children and pets. • Do not leave packaging material lying around carelessly. These may become dangerous playing material for children. • Always check the product for damages before use. Should you discover any damage, cease use of the product. If you discover damages while the product is in use (i.e.
• The LEDs get hot during use. Keep the product away from easily flammable materials when in use. • The product generates heat during use. Do not cover the product during use. • The product is suitable for both indoor and outdoor use. • Attention, LED light: Do not look directly into the LED light! Do not look into the beam directly or with optical instruments! • The mains outlet must be located near to the device and be easily accessible. • Only the included transformer may be used as a power supply.
b) Miscellaneous • Consult an expert when in doubt about operation, safety or connection of the device. • Maintenance, modifications and repairs are to be performed exclusively by an expert or at a qualified shop. • If you have questions which remain unanswered by these operating instructions, contact our technical support service or other technical personnel.
Operation Do not install or operate the product under water. Make sure the cable hangs loosely and is not overly tensioned. Failure to heed this warning may cause the cables to tear. Do not connect the product to the power supply while it is still in the packaging. Uncoil the power cable fully. Do not hang any objects from the product and do not cover the product. When inserting the ground spike into the soil, do not use any tools (e.g. hammers), as such would damage the product.
6. Loosen the lateral hexagon screws using the hexagon key provided. Adjust the angle of the projector as desired and then retighten the screws. 7. Connect the transformer to a power outlet. The projector is switched on and starts rotating. The product has no power switch and is always on as long as it is connected to the power supply. Disconnect the power supply in order to switch the LED projector off.
Technical data a) LED projector Protection type.......................................IP44 Operating voltage..................................12 V/DC, 0.3 A Power consumption..............................4.7 W Number of lights.....................................4 x 1 W LED Light color.................................................Multicolor Cable length.............................................5 m Dimensions (Ø x W).............................98 x 310 mm Distance to illuminated area.............
