User manual

Outdoors
Operating instructions
Intended use
Use this product to decorate interior and exterior spaces (IP44).
A transformer is not included and must be purchased separately.
For safety and approval purposes, you must not rebuild and/or
modify this product. If you use the product for purposes other
than those described above, the product may be damaged. In
addition, improper use can cause hazards such as short circuiting,
fire, electric shock etc. Read the instructions carefully and keep
them. Make this product available to third parties only together
with its operating instructions.
This product complies with the statutory national and European
requirements. All company names and product names are
trademarks of their respective owners. All rights reserved.
Delivery content
Curtain light
Operating instructions
Note:
The transformer (item no. 1426519) designed for this product
is not included and must be purchased separately.
Safety instructions
Read the operating instructions carefully and especially
observe the safety information. If you do not follow the
safety instructions and information on proper handling
in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will
invalidate the warranty/guarantee.
a) Persons / Product
The device is not a toy. Keep it out of the reach of children and
pets.
Do not leave packaging material lying around carelessly. These
may become dangerous playing material for children.
The product is expandable. You can combine a maximum of
1050 LEDs in one system up to a length of 50 m.
Always check the product for damages before use. Should you
discover any damage, cease use of the product.
If you notice that the product is damaged during use, do not
touch it (risk of electric shock!). Disconnect it from the power
supply immediately and discontinue use.
Protect the product from extreme temperatures, strong jolts,
flammable gases, vapours and solvents.
Do not place the product under any mechanical stress.
If it is no longer possible to operate the product safely, take it
out of operation and protect it from any accidental use. Safe
operation can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient
conditions or
– has been subjected to any serious transport-related stresses.
Please handle the product carefully. Jolts, impacts or a fall even
from a low height can damage the product.
The lights become hot during operation. Keep the product away
from highly combustible materials while operating.
Only the transformer designed for this DIY system (item no.
1426519) may be used as a power source.
When setting up the product, make sure that the cable is not
pinched, kinked or damaged by sharp edges.
Always lay the cables so that nobody can trip over or become
entangled in them. This poses a risk of injury.
Always disconnect the product from the power supply during
thunderstorms.
This product is designed to be used indoors and outdoors.
Attention, LED light:
– Do not look directly into the LED light!
– Do not look into the beam directly or with optical instruments!
This product’s flexible power supply cord cannot be exchanged
or repaired. If the cord is damaged, the product must be
disposed of.
Components of this product must not be connected to
components of products made by other manufacturers.
The connection must only be made using connectors from this
DIY system. Open ends should be sealed tightly before use.
b) Miscellaneous
Consult an expert when in doubt about operation, safety or
connection of the device.
Maintenance, modifications and repairs are to be performed
exclusively by an expert or at a qualified shop.
If you have questions which remain unanswered by these
operating instructions, contact our technical support service or
other technical personnel.
Mix & Match
100 LED warm white icicle light curtain for DIY
system
Item no. 1426524
100 LED warm white light curtain for DIY system
Item no. 1426525

Summary of content (2 pages)