User Manual

User Manual 20
tripods. Simply screw your
tripod mount into the socket
on the base of the OneStep+.
Note with some tripods,
the tripod mount will need
to be unscrewed before
you can load or exchange
filmintotheOneStep+.
Cleaning the rollers
Sometimes excess developer
paste from photos may build up
on the camera’s rollers, affect
-
ing the camera’s performance
and causing photos to show
unwanted imperfections. The
OneStep+ has a built-in roller
cleaning mode to help with this
issue. Just follow these steps:
1. Turn the camera off.
2. Openthefilmdoor.
3. Holdtheashoverride
button and press the shutter
button.
4. The camera is now in roller
cleaning mode.
5. Using a damp cloth or cot-
ton swab, gently clean the
rollers.
6. Press shutter button to
incrementally advance roller
positions.
7. Once both rollers are clean
onallsides,closethefilm
door.
8. Rollers will automatically
return to their correct
position.
Troubleshooting
& FAQ
My OneStep+ won’t eject
my photo/darkslide
Make sure that your
OneStep+ camera is charged:
Thecamera’sashcharge
LED will blink red if it doesn’t
have enough charge to op-
erate. If this is the case, you
should recharge your camera
before using the camera
again.
Make sure you still have
filminyourcamera:tocheck,
slide the power switch off
andon.Theremainingfilm
counter LEDs will indicate
how many shots you have left
inthefilmpack.IftheLEDs
ashrapidlywhenthecamera
turns on again, this means