User manual
Instruction manual
|
PS100 Mobile Storage System
15
Appropriate temperature usage
• Charge protection: The PS100 can charge your device when the ambient temperature is between
0 - 40°C. Outside this temperature range, the system automatically stops charging but will restart once the
temperature is back inside the acceptable range.
• Discharge protection: The PS100 can power your devices when the ambient temperature is between
0 - 40 °C. Outside this temperature range the system automatically stops charging your device but will
restart once the temperature is back inside the acceptable range.
ATTENTION
Make sure that the electronic device you are powering works properly prior to use. The max. power
consumption for electronic devices is 100W. Due to the different types of electric devices,
it is possible that they may not operate even if their power consumption is less than 100W.
9. Troubleshooting
If your devices are not recharging as they should using PS100 follow these steps:
1. Ensure the device has been switched on and the LED is showing the percentage of remaining charge.
2. Check the Battery Display. If it is at 20% or below, recharge your PS100.
3. Verify your device is suitable for use with the PS100.
a. All PS100 output ports have their own max. power. Check the PS100’s technical specications to ensure
your device is compatible.
b. Some devices with rechargeable batteries, like laptops and tablets, may draw more power when in use.
In these cases, power down your device and recharge it.
What should I do if the unit gets wet?
Immediately turn off the unit and wait until you are certain that it is completely dry before turning it back on.
If you are unsure about when it is safe to turn it back on, please contact after sales service.
ATTENTION
The inverter output is modied sine wave (square wave).
It is unsuitable for use with any device with an electric motor.