Instruction Manual

4
5
6
How to clean
1. To remove any residual Candy from the Nozzle, place it in hot water and leave for several minutes, allowing
the Candy to dissolve. Then use a heat resistant utensil to remove the Nozzle from the hot water. Repeat as
necessary until completely clean.
2. Ensure only the parts labelled in green on the following image are cleaned thoroughly. DO NOT clean the parts
labelled in red, as these contain electrical components that will be damaged if they come into contact with water,
which would invalidate your Guarantee.
3. Ensure all parts are completely dry before reassembling the pen.
Reassembling the Polaroid CandyPlay 3D Pen
To reassemble the pen, follow the 6 steps from ‘Taking apart the Polaroid CandyPlay 3D pen for cleaning’ but in reverse order.
Note: Before inserting a Candy Cartridge, press and hold the Retraction button for 2 seconds.
Take the white internal Candy
Chamber out of the pen.
Slide the red Piston out, using
the teeth to remove.
Remove the red Back Panel
of the pen.