User Manual

Use 2x AAA (1.5V) batteries. Alkaline batteries are recommended. (Batteries not included.)

1) Open the battery/memory card compartment door.

2) Insert the batteries properly into your digital camera, according to the polarity shown inside

the battery compartment.

3) Securely close the battery/memory card compartment door.

NOTE:

 Remove the batteries from the camera when not in use for an extended period.

 Do not mix alkaline and non-alkaline batteries.

 Some features, such as Flash, will not work if the battery power level is low.

 When the battery power is low the battery icon turns red and the camera will automatically

turn off a few seconds later.

 The energy status of the power is displayed on LCD as shown below:

Full battery power Medium battery power Low battery power

Make sure a Micro SD card has been properly inserted into your camera. (Micro SD Memory card

not included.)

To properly insert the Memory Card:

1) Turn off the camera.

2) Open the battery/memory card compartment door.

3) Insert the Micro SD Card into the slot in the direction shown on the camera (see SD icon by