User manual

98 99
This device and its antenna(s) must not be co-located
or operating in conjunction with any other antenna
ortransmitter.
For product available in the USA/Canada market, only
channel 1~11 can be operated. Selection of other
channels is notpossible.
IMPORTANT NOTE:
Federal Communication Commission (FCC)
Radiation Exposure Statement
This EUT is compliance with SAR for general population/
uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and
had been tested in accordance with the measurement
methods and procedures specified in OET Bulletin 65
Supplement C. This equipment should be installed and
operated contact with the radiator & your body.
This device complies with Industry Canada’s licence-
exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of
thedevice.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions
suivantes : (1)l’appareil ne doit pas produire de brouillage,
et (2)l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
WARNING STATEMENTS
Federal Communication Commission
InterferenceStatement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician
for help.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received,
including interference that may cause undesiredoperation.