Owner's Manual

Safety Precautions
FCC Statement
1 . This device complies with Part 15
of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
2. Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's· authority
to operate the
equipment.
NOTE: This equipment has been tested and found
to comply with the
limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used
in
accordance with the instructions, may cause harmful interference to radio
communications. However, there
is no guarantee that interference will
not occur
in a particular installation. If this equipment does cause harmful
interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into
an outlet
on a circuit different from that
to which
the receiver
is connected.
- Consult the dealer or
an experienced radio!fV technician for help.
FCC RF Radiation Exposure Statement
1 . This transmitter must not be colocated
or operating in conjunction with
any other antenna or transmitter.
2. This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance
20cm between the radiator & your body.
FCC RF Warning
This equipment must be installed and operated
in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 em from all persons and must
not be co-located or operating
in conjunction with any other antenna or
transmitter. End-users and installers must be provide with antenna installation
instructions and transmitter operating conditions for satisfying RF exposure
compliance.
Canada, Industry Canada
(IC) Notices
This Class B digital apparatus complies with Canadian ICES-003.
To reduce
potential radio interference
to other users, the antenna type andits gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.)
is not more than that permitted for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s).
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Radio Frequency (RF) Exposure Information
The radiated output power
of the Wireless Device is below the Industry
Canada
(IC) radio frequency exposure limits. The Wireless Device should
be used
in such a manner such that the potential for human contact during
normal operation
is minimized.
This device has also been evaluated and shown compliant with the
IC RF
Exposure limits under mobile exposure conditions. (antennas are greater than
20cm from a person's body).