ALL-WEATHER LOUDSPEAKER ENCEINTES TOUTES SAISONS Owner’s Manual 5601 METRO DRIVE, BALTIMORE, MARYLAND 21215, USA, 800-377-7655, FAX: 410-764-5266 www.polkaudio.
For Customer Service, call 800-377-7655 1
ATRIUM60 FEATURES: • 6 1/2” (16.5cm) long throw Polypropylene Cone driver with Butyl Rubber Surround for robust bass response. FIGURE 1 Place the speaker in a corner for more bass output. Bracket attached to side wall. • 1" (25mm) Dome Tweeter with a Neodymium Magnet for accurate high frequencies. Coloque el altavoz en una esquina para obtener mayor rendimiento de bajos. Soporte adosado a la pared lateral. • Water Resistant Power Port bass venting for deep, low distortion bass (patent pending).
PAINTING THE CABINET, BRACKET KNOBS AND BRACKET: 1. Apply two thin coats of primer to the cabinet and knobs. The bracket does not require a primer. 2. When the primer is completely dry, apply the finish color [figure 7]. 3. When the paint is completely dry, remove the masking material. 4. Do not reattach the speaker to the bracket until the bracket is mounted. Try to keep all handling of freshly painted parts to a minimum.
8. If speaker wire is being fed from a hole in the wall behind the bracket, pull this speaker wire through the hole in the bracket before mounting the bracket [figure 11]. 5. Si vous êtes certain qu’il y a un montant derrière la surface du mur, enfoncez des vis no 10 (non fournies) à travers la surface du mur et dans le montant [figure 10a]. 9. Line up the bracket, attached to the speaker, so that the screw heads pass through the large center hole of the bracket’s keyhole slot. 6.
ALTERNATE SECURE MOUNTING METHODE D’INSTALLATION PLUS SOLIDE MAKING THE CONNECTION LA CONNEXION For more solid mounting, screw the bracket directly into a weight-bearing stud on the mounting surface. Pour une installation plus solide, visez le support directement dans un montant portant du mur. Enfoncez les vis solidement à travers la partie rétrécie des fentes en trou de serrure et dans le montant. Ne laissez pas les têtes de vis dépasser.
POLK AUDIO LIMITED WARRANTY SEALING THE CABINET WITH THE POWER PORT PLUG The Power Port bass vent on the Atrium60 is an enhanced design vent. It includes a Flared “Umbrella” Diffuser for nominal (not complete) waterproofing and a special Bugscreen Protector for keeping little critters out of the cabinet. The optional (included!) Power Port Plug seals the cabinet completely, creating a military spec waterproof cabinet, but with somewhat reduced bass response.