User Manual

DB 5252, DB 6502

Figure 10

Flush mount tweeter mounting

1. Check for proper clearance:

The ﬂush mount kit is 1”

(26mm) deep.

2. Mark the center of the spot and

cut a 2” (50.8mm) diameter hole

using a hole saw, drill bit or

razor knife.

3. Assemble the cup, clamp and machine

screw loosely as shown.

4. Route wires through the round opening in the bottom of the cup.

5. Press the assembly into the 2” (50.8mm) diameter hole until the clamp edge is below the mounting surface,

then tighten the screw. The legs of the clamp can be bent outward by inserting a screwdriver through the

holes in the cup while still mounted.

6. Connect wires from the tweeter terminals of the Crossover to the tweeter itself using the faston connectors.

Connect the red wire from the (+) terminal of the Crossover tweeter output to the red (+) wire from the tweeter.

7. Mount the tweeter by snapping it into the mounting cup.

Figure 10