OEM/Integrators Installation Manual Module name：DBWA Product Name : WIRELESS ADAPTER Project：IA9QH5 SY5-U09 (USB Dongle) Syncomm Technology Corp. 10F., No. 101, Sec. 2, Gongdao 5th Rd., East Dist., Hsinchu City, Taiwan, R.O.C. Tel: +886-3-5169188 Fax: +886-3-5169111 http://www.syncomm.com.tw SYNCOMM Confidential E-Mail: sell@syncomm.com.tw Web site: Http://www.syncomm.com.
1. 2. 3. 4. 5. 6. 7. 8. 9. 10. INDEX Features .................................................................................................................................................... 3 Application .............................................................................................................................................. 3 RF Specification ......................................................................................................................................
IA9QH5 SY5-U09 page - 3 - 1. Features SYNIC Solution I2S Digital Audio Signal over USB3.0 connector 5.2GHz/5.8GHz ISM Band GFSK modulation Low BOM cost Long distance > 30m (Line of sight) Support 1-1/1-2/1-3 duplex mode Digital I2S audio interface Support no audio detection function Short delay time variation Audio format 16/24 bit, 32/44.
IA9QH5 SY5-U09 page - 4 - 3. RF Specification Item Min Typ Max Unit Channel Range 5160 ─ 5240 MHz ─ 2.5 ─ MHz 2M Mode dBm Peak power at Antenna port dBm The smaller, the better -20dB bandwidth RF Output Power Sensitivity 12 ─ -92 ─ Note Table 1 5.2GHz RF Specification Item Min Typ Max Unit Channel Range 5735 ─ 5840 MHz ─ 2.
IA9QH5 SY5-U09 page - 5 - 4. Electrical Specification Item USB Supply Voltage Operating Temperature Min 4.5 Typ 5 Max 5.5 Unit 0 25 40 ℃ Note V 2.1CH Audio Mode Consumption Current (TX_MODE) 180 mA Consumption Current (RX_MODE) 100 mA RF Power :11dBm No GPIO driving 0.1CH Audio Mode Consumption Current (TX_MODE) 130 mA Consumption Current (RX_MODE) 86 mA RF Power :11dBm No GPIO driving Table 4 Item Symbol VIH Parameter Input High Threshold Min 2.
IA9QH5 SY5-U09 page - 6 - 5. Mechanical Specification Dimension：53.1 * 13.5 * 4.5 mm PCB 4 Layers Mechanical Drawing： SYNCOMM Confidential E-Mail: sell@syncomm.com.tw Web site: Http://www.syncomm.com.
IA9QH5 SY5-U09 page - 7 - Fig 6.1 Mechanical Drawing of IA9QH5 SY5-U09 SYNCOMM Confidential E-Mail: sell@syncomm.com.tw Web site: Http://www.syncomm.com.
IA9QH5 SY5-U09 page - 8 - 6. Pin Definitions Pin 1 2 3 4 5 6 7 8 9 Name VUSB I2C_CLK I2C_DATA GND I2S_MCLK I2S_BCK SPB_I2S_DATA I2S_LRCK SPA_I2S_DATA SYNCOMM Confidential E-Mail: sell@syncomm.com.tw Web site: Http://www.syncomm.com.
IA9QH5 SY5-U09 page - 9 - 7. FCC Statement COMPLIANCE INFORMATION 15.19 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: A. This device may not cause harmful interference, and B. This device must accept any interference received, including interference that may cause undesired operation. 2. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 15.
IA9QH5 SY5-U09 page - 10 - 8. IC Statement This device complies with the Canada portable RF exposure limit set forth for an uncontrolled environment and is safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available. Canada, Industry Canada (IC) Notices This Class B digital apparatus complies with Canadian ICES-003.
IA9QH5 SY5-U09 page - 11 - 9. Important Safety Instructions 1. Do not use this apparatus near water. 2. Clean only with dry cloth. 3. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 4. The equipment could be used at maximum 40 degree C ambient temperature. 5. Do not open the equipment to reduce the risk of electrical shock. For safety reasons it is only allow to the opened by qualified service personnel. 6.
IA9QH5 SY5-U09 page - 12 - 10. Instructions to the OEM/Integrator This module has been granted modular approval for mobile applications. OEM integrators for host products may use the module in their final products without additional FCC/ISED (Innovation, Science and Economic Development Canada) certification if they meet the following conditions. Otherwise, Additional FCC/IC approvals must be obtained. ⚫ The OEM must comply with the FCC labeling requirements.
IA9QH5 SY5-U09 page - 13 - SYNCOMM Confidential E-Mail: sell@syncomm.com.tw Web site: Http://www.syncomm.com.
IA9QH5 SY5-U09 page - 14 - SYNCOMM Confidential E-Mail: sell@syncomm.com.tw Web site: Http://www.syncomm.com.
