Installation Manual

IA9QH5 SY5-U09 page - 9 -
SYNCOMM Confidential
E-Mail: [e-mail]
Web site: Http://www.syncomm.com.tw
7. FCC Statement
COMPLIANCE INFORMATION
15.19
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
A. This device may not cause harmful interference, and
B. This device must accept any interference received, including interference
that may cause undesired operation.
2. Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
15.21
Note: The grantee is not responsible for any changes or modifications not expressly approved by
the party responsible for compliance. Such modifications could void the user’s authority to
operate the equipment.
15.105(b)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement
1. This transmitter must not be collocated or operating in conjunction with any other antenna or
transmitter.
2. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cmbetween
the radiator & your body.
3. FCC RF Warning.
This equipment must be installed and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter. End users and installers must be provided with antenna installation instructions and
transmitter operating conditions for satisfying RF exposure compliance.