O W N E R ’ S M A N U A L MM2084 MM2104 MM2124 MM2154 MM2084DVC MM2104DVC MM2124DVC MM2154DVC WWW.POLKAUDIO.
Polk/MOMO MM Subwoofers Safe Limits Of Operation • Four Single Voice Coil (SVC) Subs: 8" (MM2084), 10" (MM2104), 12" (MM2124) & 15" (MM2154). • Four Dual Voice Coil (DVC) Component Subs: 8" (MM2084DVC), 10" (MM2104DVC), 12" (MM2124DVC) & 15" (MM2154DVC). • Ultra-stiff Metallized ABS Dynamic Balance Cone for massive bass. • Dish Cone design is supported by a Vented Cone Coupler, increasing axial rigidity.
Polk/MOMO MM Subwoofers • Quatre subwoofers à bobine acoustique simple (SVC): 8" (MM2084), 10" (MM2104), 12" (MM2124) et 15" (MM2154). • Quatre subwoofers à bobines acoustiques jumelées (DVC): 8" (MM2084DVC), 10" (MM2104DVC), 12" (MM2124DVC) et 15" (MM2154DVC). • Cône Dynamic Balance en ABS métallisé ultra-rigide pour des graves massifs. • Technologie «Dish Cone»: le cône est supporté par un coupleur ventilé pour accroître la rigidité axiale.
Basic Wiring Diagrams For MM Series Single Voice Coil Subs Schéma de câblage pour les subwoofers à bobine simple (SVC) de la Série MM + + + + AMP - AMP - - + Single 4 Ohm Wiring Câblage simple 4 Ohm - Parallel 2 Ohm Wiring Two 4 Ohm speakers will present a 2 Ohm load. Make sure that your amplifier is 2 Ohm stable when configured in bridge mode. Consult your amplifier’s owner’s manual before wiring in this configuration.
With coils and speakers wired in parallel, 2 dual 4 Ohm speakers will present a 1 Ohm load. (Not recommended unless amplifier is rated for 1 Ohm operation.) Deux h.-p.s, à bobines 4 Ohm jumelées configurées en parallèle, câblés en parallèle constituent une charge de 1 Ohm. (Non recommandé à moins que l’amp. soit capable de soutenir une charge de 1 Ohm.) With the coils wired in series and the speakers wired in parallel, 2 dual 4 Ohm speakers will present a 4 Ohm load.
Building an Enclosure for MM Series Who Is Going To Build Your Subwoofer Enclosure? Since the subwoofer enclosure is so critical to getting the best performance from your Polk/MOMO subs, you should ask yourself the following questions: 1. Do I really enjoy working with my hands? 2. Do I have good woodworking and mechanical skills? 3. Do I have, or have access to, woodworking and electrical tools? 4.
Construction d’un caisson pour la Série MM Qui construira votre caisson de subwoofer? Puisque le caisson du subwoofer est d’une importance capitale au rendement optimal de votre subwoofer Polk/MOMO, posez-vous les questions suivantes: 1. Est-ce que j’aime travailler avec mes mains? 2. Suis-je habile en menuiserie et en mécanique? 3. Ais-je accès à des outils de menuiserie et à des outils électriques? 4.
Parts You Will Need To Build Your Enclosure When building a subwoofer enclosure you will find that there are numerous materials recommended for construction. 1. Medium density fiberboard (MDF) 2. Marine grade plywood 3. Particle board (the smaller the particles the better) These materials range in price as well as availability. Particle board is the most common, least costly, and can be purchased at most hardware stores.
Designing Your Polk/MOMO Subwoofer Enclosure Step By Step Élaboration de votre caisson pour subwoofer Polk/MOMO When designing your subwoofer enclosure, the first thing you need to figure out is, just how large an enclosure will fit in your vehicle. When an enclosure is going in the trunk of a car, you first need to measure your trunk to find the maximum height, width, and depth you can use. Pay attention to trunk hinges and tension bars.
It is not advised to use silicone around your subwoofer when mounting it to the baffle. Instead, we recommend using the Anti-Resonance Trim Gasket supplied with your Polk/MOMO subwoofer. When mounting your subwoofer to the baffle board, pre-drill your mounting holes. This will make the mounting of your subwoofer easier and will help prevent damage to your subwoofer from a slip of the drill. When securing your subwoofer to the enclosure we recommend using wood screws that are at least 1.25" long.
SKETCH YOUR INSTALL HERE: ESQUISSEZ VOTRE INSTALLATION ICI: WWW.POLKAUDIO.
Polk/MOMO Subwoofer Specifications THIELE / SMALL PARAMETERS Fiche technique des Subwoofers Polk/MOMO PARAMÈTRES THIELE / SMALL MM2084 MM2104 MM2124 Driver Complement/Transducteur 8" 10" 12" 15" Nominal Impedance/Impédance nominale 4 Ohms 4 Ohms 4 Ohms 4 Ohms Frequency response/Réponse en fréq. 26 – 200 Hz 24 – 200 Hz 23 – 200 Hz 18 – 150 Hz Fs (Hz) 43 Hz 35 Hz 31 Hz 24 Hz Re 3.3 Ohms 3.3 Ohms 3.3 Ohms 3.5 Ohms Le 1.84 mH 2.56 mH 2.42 mH 3.01 mH Qms 15.13 13.77 13.66 10.
Polk/MOMO Subwoofer Specifications THIELE / SMALL PARAMETERS Fiche technique des Subwoofers Polk/MOMO PARAMÈTRES THIELE / SMALL MM2084 DVC MM2104 DVC MM2124 DVC MM2154 DVC Driver Complement/Transducteur 8" 10" 12" 15" Nominal Impedance/Impédance nominale 4 Ohms 4 Ohms 4 Ohms 4 Ohms Frequency response/Réponse en fréq. 26 – 200 Hz 24 – 200 Hz 23 – 200 Hz 18 – 150 Hz Fs (Hz) Re Le 43 Hz 3.25 Ohms per Coil 1.94 mH 38 Hz 3.25 Ohms per Coil 2.59 mH 31 Hz 3.25 Ohms per Coil 2.29 mH 24 Hz 3.
Polk/MOMO Series Limited Warranty Polk Audio, Inc., warrants to the original retail purchaser only. This warranty will terminate automatically prior to its stated expiration if the original retail purchaser sells or transfers the Product to any other party. Polk Audio, Inc.
Pour permettre à Polk Audio de vous offrir le meilleur service de garantie possible, veuillez enregistrer votre nouveau produit en ligne à l’adresse web : www.polkaudio.com/registration - ou contactez le Service à la Clientèle de Polk au 800377-7655 aux États-Unis et au Canada (à l’extérieur des É.U.: 410-358-3600) dans les dix (10) jours suivant la date de l’achat original. Assurez-vous de conserver votre reçu d’achat original.
5601 Metro Drive Baltimore, Maryland 21215 (800) 377-7655 www.polkaudio.com www.polkmomo.com Contact Polk Audio Customer Service 800-377-7655 (M-F, 9-6 EST, US only) or via email polkcs@polkaudio.com. Outside the US, call 410-358-3600. Vous pouvez contacter le Service à la Clientèle de Polk Audio (L-V, 9h-18h HE, É.-U. et Canada seul. au: 800-377-7655 ou par courriel : polkcs@polkaudio.com. (ext. des É.U et du Canada, 410-358-3600) “Polk Audio” is a trademark of Britannia Investment Corporation.
