User Manual

Safety Precautions
FCC Statement
1. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause
harmful interference.
(2) This device must accept any
interference received, including
interference that may cause
undesired operation.
2. Any Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- | Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
FCC RF Radiation Exposure Statement
1. This transmitter must not be colocated
or operating in conjunction with any other
antenna or transmitter.
2. This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with minimum distance 20cm
between the radiator & your body.
FCC RF Warning
This equipment must be installed and operated
in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 20 cm from
all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter.
End-users and installers must be provide with antenna
installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
IC RF Radiation Exposure Stament
This device complies with the Canada portable
RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as
described in this manual. The further RF exposure
reduction can be achieved if the product can be kept
as far as possible from the user body or set the device
to lower output power if such function is available.
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian
ICES-003. To reduce potential radio interference to
other users, the antenna type andits gain should be so
chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that permitted for successful
communication.