PA D4000.
SUB INT UB LEVEL SOURCE INPUT FL SUB INPUT 38Hz SUB INT SUB 40Hz 220Hz REMOTE LEVEL CONTROL SUB SONIC LEVEL LPF INPUT FL PA D5000.5 HPF End Panel Layouts PA 4a D4000.
GND REM 12V Amplifier Wiring L L R R 25A 25A L L R Amplifier Installation R Power Connections • PA D4000.4 Fuse Size: 2 x 40 AMP ATC • Power connections accept up to 4 AWG wire. • 4 AWG power and ground wire recommended for optimal performance. • Connect +12V to the battery through fuse holder. This connection provides +12V main power to the amplifier. 4Ω minbe fused within 12" of the battery.
9. 10. Battery and ground connections to the vehicle should be made with crimped ring terminals of the appropriate size (surface area is what counts;) soldering the terminals after crimping is also recommended. Due to the high-frequency MOSFET switching power supply, filtering the power cable is not generally required (remember that the amp can’t deliver full output if the power supply is restricted.
Troubleshooting Tips Symptom Probable Cause Specifications Action To Take Audio cycles on and off Thermal protection engages when amplifier heat sink temperature exceeds 85° C (185° F). Make sure there is proper ventilation for amplifier and improve ventilation as needed. Loose or poor audio input. Check line level connections and repair or replace as needed. Loose power connections. Check power wires and ground connections and repair or replace as needed.