PA D5000.
TOOLS OF THE TRADE Listed next are the majority of the tools required to perform an installation. Having the proper tools will make the installation that much easier.
Amplifier Wiring WARNING! 4Ω min/bridged Power Connections • PA D5000.5 Fuse Size: 2 x 40 AMP ATC • Power connections accept up to 4 AWG wire. 4Ω min/bridged • 4 AWG power and ground wire recommended for optimal performance. • Connect +12V to the battery through fuse holder. This connection provides +12V main power to the amplifier. • Power wire must be fused within 12" of the battery. • Ground the amplifier using a good chassis ground as close as possible to the amplifier.
Step By Step Installation 1. Determine the location for the amplifier. Refer to the Mounting Locations section of this guide. 2. Decide on the system configuration for your amplifier. For system suggestions, refer to the Speaker Wiring Diagrams section of this guide. 3. Run all the wires from the amplifier location to the speakers, source unit, and battery. Do not connect the battery at this time.
Troubleshooting Tips Symptom Specifications Probable Cause Action To Take Amplifier PA D5000.5 Amplifier PA D5000.5 Loose or poor audio input. Check line level connections and repair or replace as needed. Type Bridgeable Class D MOSFET Filter Switch (Rear) 2-position (Full, HPF) Loose power connections. Check power wires and ground connections and repair or replace as needed.
