User Manual

The USB Dual Port serial mode.
The Serial Settings tab in the Maestro Control Center.
The Maestro can be configured to be in one of three basic serial modes:
USB Dual Port: In this mode, the
Command Port can be used to send
commands to the Maestro and receive
responses from it. The baud rate you set in
your terminal program when opening the
Command Port is irrelevant. The TTL Port
can be used to send bytes on the TX line
and receive bytes on the RX line. The baud
rate you set in your terminal program when
Pololu Maestro Servo Controller User’s Guide © 2001–2019 Pololu Corporation
5. Serial Interface Page 47 of 102