Manualshelf

Data Sheet

ManualsBrandsPololu ManualsMotor ControllersPololu RC Switch w/ Digital Output
12345678910
When these outputs are high they will be at the same voltage level as VCC. When low, these outputs will be at 0 V
(ground). These outputs do not have resistors in series with them. Each output can source or sink up to 25 mA.
Configuration interface
The learning mode jumper on the top of the board can be used to get the device into learning mode and configure it.
The configuration procedure is described in Section 9.
Pololu RC Switch with Digital Output, bottom
view with dimensions.
Included hardware
A 7-pin 0.1″ straight breakaway male header [https://www.pololu.com/product/965] is included with the Pololu RC
Switch with Digital Output. The header pins can be soldered in and used to connect the RC switch to perfboards or
breadboards [https://www.pololu.com/category/28/solderless-breadboards].
Pololu RC Switch with Digital Output with
included hardware.
2.2. Connecting the RC Switch with Digital Output
The typical way to connect the Pololu RC Switch with Digital Output is shown in the diagram below:
Pololu RC Switch User’s Guide © 2001–2015 Pololu Corporation
2. RC Switch with Digital Output Page 5 of 35