AN4846 Application note Using multiple VL53L0X in a single design Introduction The purpose of this document is to give an example of how multiple VL53L0X devices can be placed on a board design while only using a single I2C interface to interact with the devices. Figure 1. VL53L0X device May 2016 DocID029133 Rev 1 1/7 www.st.
Contents AN4846 Contents 1 Purpose . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2 Multiple VL53L0X application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 3 2/7 2.1 VL53L0X control management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2.2 VL53L0X API management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Revision history . . . . . . . . . . . . . . . . . .
AN4846 1 Purpose Purpose The purpose of this document is to give an example of how multiple VL53L0X devices can be used on a board design while only using a single I2C interface. The VL53L0X is a ranging sensor that uses time of flight principle to measure distance to an object. The control and output interface is an I2C interface. Each VL53L0X device has both a XSHUT pin and an interrupt (GPIO1) pin, which will be used in this design setup for using multiple devices.
Multiple VL53L0X application AN4846 Figure 2. VL53L0X typical application 9'' 9/ / ; $9''9&6(/ $9669&6(/ *1' *1' ;6+87 *1' *1' $9'' 6&/ 6'$ '1& *3,2 5 N ;6+87 9/ / ; *3,2 ,17 5 N & & ) Q) 6'$ 6&/ 2.
AN4846 Multiple VL53L0X application Figure 3.
Revision history 3 AN4846 Revision history Table 1. Document revision history 6/7 Date Revision 23-May-2016 1 Changes Initial release.
AN4846 IMPORTANT NOTICE – PLEASE READ CAREFULLY STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, enhancements, modifications, and improvements to ST products and/or to this document at any time without notice. Purchasers should obtain the latest relevant information on ST products before placing orders. ST products are sold pursuant to ST’s terms and conditions of sale in place at the time of order acknowledgement.