User Manual

14
Problem Solution
No Audio Make sure the Power switch on the transmitter and receiver is set to ON and that the LED indicator is lit�
If LED indicator is not lit, make sure batteries are properly installed (see Battery Installation instructions
above)�
Make sure the proper connections have been made (see Recording to HDSLR, Video Camera, or Audio
Device section)�
Make sure the Channel Selector Switch on the receiver and transmitter are set to the same channel�
Make sure video camera, HDSLR camera, or audio device is in record mode and the record level is set�
Too much ambience is
being picked up
When using an omnidirectional microphone (as provided with the CAM-2W system) the microphone may be
picking up too much ambience�
Make sure the microphone is as close to the subject as possible.
If there is still too much ambience, try switching to a cardioid microphone (PL-2WC), as this will record less
of the sound from the peripheral area�
Other Troubleshooting Issues