User Manual

INSTALLING BATTERIES

The Transmitter and Receiver are each powered by a 9 V alkaline battery. Battery life is approximately 8 hours of operating time.

For installing batteries into the Transmitter and Receiver:

1. Remove the Battery Compartment Cover by pressing down and sliding the compartment in the direction of

the arrow�

2. Place the cap snuggly over the battery

terminals�

3. Place the Ribbon on the bottom of the

compartment with enough temporarily draped

over the edge so it can be tugged to dislodge

a spent battery later�

4. Place the battery and cap into the

compartment making sure that it is fully

seated�

5. Replace the Battery Compartment Cover� Make sure the cover slides into place easily�

6. Note: To avoid possible damage, batteries should be removed if the unit will not be used for a lengthy amount of time�

7. Alternatively, the receiver can be powered by a 9 V DC power supply (not included)�