ULW-16 System User Manual
12
Note: Make sure the camera end of the cable is plugged into your camera, and the line-level end of the cable is plugged into the
receiver.
4. Adjust your camera’s input for the sufcient recording level. For more information on how to do this, consult your camera’s
instruction manual.
Transmitter (ULW-16 only)
1. Use the integrated belt clip to secure the transmitter to your talent. Use the included tie clip to place the microphone on your
talent.
2. If you are connecting to a line-level source, use an appropriate cable to connect to the mono 3.5 mm jack.
Note: The line-level input overrides the microphone input.
The transmitter’s TX LED will glow red when the unit is transmitting, and the receiver’s RF LED will glow red when the unit is
receiving a strong radio frequency signal.
You can monitor the transmission by plugging headphones into the receiver’s headphone output. This allows you to monitor in real
time without the latency that often occurs when monitoring via a camera’s headphone output.
The receiver’s audio output can be connected to an audio recorder for remote eld-recording or to a PA system for live sound
presentations.