User Manual
10
b. Change the channel with short presses of the up or down buttons while the channel number is blinking.
c. The channel number will continue to blink for 6 seconds. The channel number stops blinking to indicate that the channel
has been selected.
Note: If you experience interference or noise on one channel, try a different channel. If you are using multiple ULW-16 wireless
systems, make sure each system is set to a different channel – at least three channels apart as a guard band.
4. With the headphone volume set to a low level, plug in an earpiece or headphones to the receiver and gradually raise the level to
a comfortable volume for monitoring the transmission.
5. Gradually turn up the transmitter’s level control and make sure a sufcient level is being transmitted to the receiver. Setting to
the level target mark will generally ensure a good signal. The objective is to transmit the highest possible level without distortion
for the best signal-to-noise ratio throughout the signal path.
ULW-16-HL
1. Turn on the handheld transmitter by moving the power switch to the ON position. The LCD display will illuminate showing the
selected channel and battery icon.
Note: If you are connecting the receiver to a sound system, mute the sound system. Do not monitor with headphones at this
stage. Anytime you are changing channels, remove your headphones and mute connected sound systems to avoid audible RF
noise bursts.
2. Set the handheld transmitter and the receiver to the same channel. If you are experiencing interference or noise on one channel,
try a different channel.