User Manual

8
INSTALLING BATTERIES
The transmitter, receiver, and handheld transmitter are each powered by two AA batteries. To install the batteries, follow
these steps:
Transmitter and Receiver
1. Make sure the unit is turned off by rotating the control knob to the OFF position.
2. Gently squeeze the battery compartment panel by the arrows on both sides
and pull out to swing the panel open.
3. Insert fresh batteries in the proper orientations.
4. Close the panel completely so it locks into place.
Tip: You can use rechargeable AA batteries with the receiver and transmitter and recharge them by inserting them into the Polsen
ULW-BBCH charger (sold separately). Use only rechargeable batteries with the charger. Do not attempt to charge standard batteries
– this may result in damage to the unit and void the warranty.
Handheld Transmitter
1. Unscrew the battery compartment cover exposing the battery compartment.
2. Insert fresh batteries according to the orientation diagram inside the
compartment.
3. Replace the battery cover by screwing it rmly back into place.