User Manual

14
Selecting channels:
1. Press and hold the up or down button [ ]for 2 seconds. The channel number on the LCD display [ ]
will blink.
2. Change the channel with short presses of the up or down buttons while the channel number is blinking.
3. The channel number will continue to blink for 6 seconds. The channel number stops blinking to indicate that
the channel has been selected.
Once the transmitter and receiver have been set to the same channel, the RF input indicator [
] will glow.
Setting the Volume
Adjust the level control knob on the transmitter so the audio level meter on the receiver indicates that it’s
receiving a strong signal without peaking.
On the receiver, press and hold the set button until the auto lock icon disappears. Use the up and down buttons
to adjust the volume output level. The objective is to transmit the highest possible level without distortion.