User Manual

INSTALLING BATTERIES

The transmitter and handheld transmitter are each powered by two AA batteries. To install the batteries, follow

these steps:

Transmitter

1. Make sure the unit is turned off by rotating the level control knob to the off position.

2. Gently squeeze the battery compartment panel by the arrows on both sides, and pull out to swing the

panel open.

3. Insert fresh batteries in the proper orientations.

4. Close the panel completely so it locks into place.

Tip: You can use rechargeable AA batteries with the transmitter, and recharge them by inserting them into the

Polsen ULW-BBCH charger (sold separately). Use only rechargeable batteries with the charger. Do not attempt

to charge standard batteries—this may result in damage to the unit and void the warranty.

Handheld Transmitter

1. Unscrew the battery compartment cover to expose the battery compartment.

2. Insert fresh batteries according to the orientation diagram inside the compartment.

3. Replace the battery cover by screwing it rmly back into place.